- Summary
- Case Studies
- Specification
- Description
Oil Removal Filter
Article: The Best Way to Dewater New Transformer Bunds
The Green Rhino® Oil Removal Filter fits to a bund or tank and removes all hydrocarbon contaminants from the outflow. It is designed for applications with higher flow (up to 80L/min) and/or a higher risk or level of contamination. The filter will retain up to 14 litres of oil before needing to be replaced
Water enters the filter from the bund outflow and passes through the smart polymer hydrocarbon filter. The smart polymer turns hydrocarbons into solid rubber, trapping them inside. Clean water is discharged through the outer surface of the filter. Hydrocarbons are reduced to non-detect levels (as low as 0.01ppm oil concentration).
A wide range of hydrocarbons can be captured, including dielectric fluids, oil, diesel and used motor oils.
When all the polymer has been activated, flow is naturally blocked so no leakage can occur. This also means that the cartridges deliver a failsafe response when a catastrophic breach occurs. A build-up of water in the bund indicates that the filter needs replacing.
These filters require minimal maintenance as they have no mechanical parts and no power requirements.
A fitting kit enables the filter to be removed and replaced without any leakage of contaminants occurring.
Oil Removal FilterHigher capacity transformer bund dewatering filter
Book A Site Demo Call 01206 299388 for stockist details |
|||||||||||
|
|||||||||||
High capacity filter for dewatering bunds and tanks. Cost-efficient alternative to oil-discriminating pumps and vacuum tankering. |
Oil Removal Filter
Higher capacity transformer bund dewatering filter
- Easy to install solution for higher risk sites
- Failsafe, low-cost alternative to oil-discriminating pumps, interceptors and vacuum tankers
- Discharges water to less than 5ppm oil
- Contains our smart polymer which converts oil into solid rubber so it can’t escape
- Automatically shuts off on detection of catastrophic breach/when filter needs replacing
- Minimal maintenance - no mechanical parts and no power requirement
Book A Site Demo Call 01206 299388 for stockist details
CODE |
PRODUCT |
SIZE |
FLOW RATE |
CAPACITY |
GRR 03 10 00 HRF |
Oil Removal Filter (4” Camlock Fitting) |
59.3 x 28.4cm |
80L/min |
Up to 14L oil |
See also
Low-cost, low-maintenance and scalable solution for dewatering transformer bunds & fuel storage areas.
The smarter, cleaner way to soak up spills. 100% retention of contaminants meaning pillows can be wrung out safely.
Oil filtration system which can be installed above or below ground, at the end of a run, or connected to a pump.